Insulated Glass Units - Specifications

Options & Possibilities

  • Minimum Size: 380 x 180mm
  • Maximum Size: 3500 x 2500mm
  • Aluminium Spacer Widths Available: 6mm, 8mm, 10mm, 12mm, 14mm & 16mm and up to 27mm
  • Aluminium Spacer Colours Available: Black and Silver
  • T Spacer Widths Available: 8mm, 10mm, 12mm & 14mm, wider on request
  • T Spacer Colour Available: Black only

Ordering & Specifying

  • When specifying and ordering IGU’s, please confirm the following:
  • Outer glass: thickness / type / coating position / pattern
  • Spacer: width / type (argon or air) / colour (black / silver)
  • Inner glass: thickness / type / coating position / pattern
  • Secondary seal type (Polysulphide is standard, specify if structural silicone is required)

Technical Mandatories

Glazing compounds and sealants may react with the IGUs.

  • For all installations JELD-WEN Glass Australia recommends a non-acidic silicone with a neutral base be used Storage Instructions: Glass should be stored in an upright position, under the following conditions:
    • In a dry, well-ventilated warehouse
    • Under no circumstances stored outside
    • Glass should be separated with cork pads/paper interleaving for transport
  • Do not expose edges to standing water and moisture, as this can result in seal failure – please refer to the Handling, Storage and Installation Instructions
  • Units transported to and installed at altitudes greater than 800m above sea level may exhibit altitude pressure problems and must have capillary tubes for pressure equalisation – please contact JELD-WEN Glass Australia for details.